Motor controller with VESC firmware for 14-84V voltage and 400A maximum current.
Unlike conventional controllers for electric vehicles (for example, FarDriver, Kelly, Votol), Flipsky 75200 supports not only analog, but also digital input. Therefore, Flipsky is perfect for use in ground drones with remote radio control. It is not necessary to install any digital-analog transmitters.
Specs:
- Firmware: 5.2, supports firmware upgrade
- Voltage: 14-84V (safe for 4-20S)
- Continuous current: 200A
- Burst: 300A
- BEC: 5V@1A>
- Support Modes: DC, BLDC, FOC (sinusoidal)
- ERPM: 150000
- Communication Ports: USB, CAN, UART, SPI, IIC
- Supported Sensors: ABI, HALL, AS5047, AS5048A
- Input Source Support: PPM, ADC, NRF, UART
- Supported Sensorless: Yes
- Regenerative capacity: Yes
- Programmable via VESC_TOOL: Yes
- Size:130x67.7x40.1mm
Features:
1.Adjustable protection against: low voltage protection, high voltage protection, over current protection, temperature abnormal protection, mosfets / motor over temperature protection.
2.Support various control modes: Current / Duty cycle / Speed / PID control modes.
3.Support the function of balancing car by connecting the IMU module through the IIC interface; support inertial measurement unit modules such as MPU9250, MPU9150, MPU6050, LSM6DS3, BMI160.
4.CPU:32F405 with frequency 168MHz
5.Aluminum PCB with good heat dissipation to expand life span.
6.Two COMM ports: UART bluetooth module, screen display or remote controller supportable.
Warm tips:
Phase filering is not available for Flipsky ESC75100 and 75200!
Please turn off the phase filter function and choose "false" in vesc_tool when use firmware version on or above 5.3 (VESC_TOOL 3.01). Without turning off the phase filter will result in esc damage. Please do not restore the default parameters when using the wizard interface.
New products:
There is also a Flipsky 75450 version available, which can work for a long time with a current of 450A, and at its peak supports up to 1200A!
