Original sine programmable controller Kelly KLS 7230ST. Among the electric bikes we sell, it is used in CityCoco Long Range Performance.
One of the best on the market of programmable controllers for brushless motors.
Sinusoidal signal allows to achieve very precise engine control, lack of noise, high efficiency and maximum torque, possible soft start site.
There is a possibility with the help of a PC or Android to change many settings in a very wide range, namely:
- Separately exhibit phase and the battery current. Battery current can be from 20% to 100% of phase.
- Limit the minimum and maximum battery voltage (from 24V to 90V) in order to protect it.
- Adjust the smoothness of the start and the power of regenerative braking in any range.
- Configure within wide limits current flow at a certain position of the accelerator handle.
- To regulate the operating voltage of the accelerator handle, which makes it possible to obtain protection against self-starting from a place in the event of damage (short circuit of the Hall sensor contacts) of the accelerator handle.
- Adjust the temperature at which the power will be limited, and then turn off the controller and the engine (a thermal sensor must be installed in the engine).
- Adjust the output voltage to the Hall sensors within 5-12V.
- Tune 5 additional buttons that are activated when connected to 12 V. By default, the lever / pedal switch, brake switch, reversing switch, front switch and acceleration switch (Boost).
- Connect additional throttle handles (for reversing, for adjusting regenerative braking, or for connecting a parking step).
Features:
- Ability to connect color on-board computer 750C (from the factory, the firmware does not support it, so if you buy such a controller not from us, it will not work with such displays).
- Support for engines with any number of poles.
- Supports up to 70,000 electrical rpm.
- Operation frequency up to 20 kHz.
- Operating temperature range: -40 to 100 ℃ (temperature MOSFET).
- Rated current: 50A
- limiting long-term current: 120A
- Peak current: 300A (our and not only measurements show real 400A).
- Peak power greater than 20 kW.
The capabilities of the controller can be estimated from the video:
Customers who bought a scooter in our store get a 10% discount.
